Getac Technology Corporation V110GD Manual De Usuario

© 2011 Microchip Technology Inc.

DS61168C-page 79

PIC32MX1XX/2XX devices contain an internal Flash
program memory for executing user code. There are
three methods by which the user can program this
memory:
1.

Run-Time Self-Programming (RTSP)

2.

EJTAG Programming

3.

In-Circuit Serial Programming™ (ICSP™)

RTSP is performed by software executing from either
Flash or RAM memory. Information about RTSP
techniques is available in Section 5. “Flash Program
Memory”

 (DS61121) in the “PIC32 Family Reference

EJTAG is performed using the EJTAG port of the
device and an EJTAG capable programmer. 
ICSP is performed using a serial data connection to the
device and allows much faster programming times than
RTSP. 
The EJTAG and ICSP methods are described in the
“PIC32 Flash Programming Specification” (DS61145),
which can be downloaded from the Microchip web site.

This data sheet summarizes the features
of the PIC32MX1XX/2XX family of
devices. It is not intended to be a
comprehensive reference source. To
complement the information in this data
sheet, refer to Section 5. “Flash
Program Memory”

 (DS61121) in the

, which

www.microchip.com/PIC32

).

Some registers and associated bits
described in this section may not be
available on all devices. Refer to

 in

this data sheet for device-specific register
and bit information.