Capital Prospect Ltd AM001 Manual De Usuario

 
You should arm the system when you are the last person to leave the house.  By arming the 
system, the control panel will call the preprogrammed emergency phone numbers and siren will 
sound when break-in occurs.   
 
Note: Only arm the system when nobody is expected to be inside the premises.  When 
someone is expected to be within the premises, the system should not be armed. 
 
To arm the system, follow the procedures below: 
 
1.  Press “Arm” button on the control panel when no sensors are triggered.  You can also use 

the keychain remote to arm the system by pressing button 1 on the remote. 

 
Note:   

• 

The control panel cannot be armed if there are triggered sensors.  Make sure all 
sensors are in closed position, i.e. (close all doors, windows, no movement should be 
detected etc).    

• 

The control panel can be armed if there are sensors with low battery or failure warning.  

 
2.  After pressing the “ARM” button, the “ARM” LED will flash and you will have 45 seconds to 

leave the premises, this is called the exit delay.  You will hear beeping during the exit delay 
interval.  The beeping rate will change from slow to fast, the faster the beep rate, the less 
time you have left to leave the premises before the siren sounds.  

 
3.  When the exit delay expires, you will hear “System Armed” and beeping will stop and the 

ARM LED will be on steadily.  This indicates the system is now armed. 

 
Note: The control panel can also be armed even nobody is home, with a touch tone phone.  
Please refer to “Remote Operation by Telephone” 
 

 
If you trigger a sensor when entering a house with an armed control panel, you will trigger the 
entry delay.  You will have 30 seconds to disarm the control panel.  Otherwise, the siren will 
sound and emergency calls will be made.  To disarm the control panel, follow the instructions 
below.  
 
1.  If any sensors are now triggered when the control panel is armed, the system will beep for 

30 seconds, and ARM LED will flash during this entry delay interval.  The faster the beep, 
the less time you have left to disarm the control panel before the siren sounds. 

 
2.  You must enter a valid password (either the Master Password, or Secondary Password) in 

order to disarm the system before the entry delay expires.  The system can also be 
disarmed by pressing button 3 on the keychain remote. 

 
3.  When a valid password is entered, you will hear “System Disarmed” and the entry delay 

beeping will stop, the ARM LED will be off.