Capital Prospect Ltd AM001 Manual De Usuario

 
Note:  

• 

The control panel can also be armed even nobody is home, with a touch tone phone.  
Please refer to “Remote Operation by Telephone”. 

• 

If 3 consecutive incorrect passwords are entered, alarm will sound immediately and the 
control panel will be in panic mode, and start calling the emergency phone numbers. 

 

 
If you hear the announcement from the control panel “System Panic” after disarming the system, 
that means at least one sensor was activated which caused the alarm to sound while you were 
away.  Following the procedures below to set the control panel back to standby mode. 
 
1.  There will be flashing LEDs indicating the sensor(s) that triggered the alarm.  You may want 

to check the condition of the triggered sensor(s), the sensor(s) may be damaged if there 
were break-ins. 

2.  You need to reset the sensor by manually triggering it twice, i.e. open and close a door / 

window sensor, or walk in front of the motion sensor.   The LED representing that sensor will 
then stop flashing. 

3.  You must now enter the password again on the control panel 

or press the button 3 of the 

keychain remote

, as an acknowledgement of the alarm event.  This will set the control panel 

back to standby mode.   

 

Note: The control panel can also be disarmed even nobody is home, with a touch tone phone.  
Please refer to “Remote Operation by Telephone” 

 
If you are forcibly compelled to disarm the control panel, you may enter the Duress Password.  
Entering the duress password will stop the siren from sounding but the control panel will silently 
call the emergency phone numbers for help.  The called party will hear the voice announcement 
“System Panic”.  
 
 
 

 
Pressing the panic button will cause the siren to sound and outgoing calls will be made to the 
preprogrammed phone numbers, “System Panic” will also be announced.  This can be used in 
any emergency situation.   You can also press the panic button on the keychain remote to 
perform the same function. 
 
To stop the siren, user can enter either the Master Password, or the Secondary Password.  You 
can also press button 3 on the keychain remote to perform the same function.  This will 
terminate both the siren and the control panel from calling the rest of the emergency phone 
numbers.