Capital Prospect Ltd AM001 Manual De Usuario
•
If the zone LED remains off, that indicates that zone is not occupied by any sensor.
•
If the zone LED flashes once, that indicates sensor 1 of that zone is occupied.
•
If the zone LED flashes twice, that indicates sensor 2 of that zone is occupied.
5.
You may now select which sensor lo
ase
zone and sensor number
by pressing buttons [1
utton
prese
6 to 0 represent sens
ones
r sel
ensor location, you will
hear 3 beeps and “Zone_ Sensor_ E
ory”.
rms the selected sensor
has been erased, and
OG] L
ff. To erase another sensor, repeat the
above steps.
Sensor 1
Sensor 2
cation to er
. Select the
] to [0]. B
s 1 to 5 re
1 to 5. Afte
nt sensor 1 for zones 1 to 5. Buttons
ecting the s
or 2 for z
mpty Mem
This confi
the [PR
ED will be o
Zone 1
Button [1]
Button [6]
Zone 2
Button [2]
Button [7]
Zone 3
Button [3]
Button [8]
Zone 4
Button [4]
Button [9]
Zone 5
Button [5]
Button [0]
e Remotes / Receiver
E
ras
Follow the instructions below to erase keychain or keypad remotes / receivers.
1.
1.
Press the [PROG] button on the side of the control panel, the [PROG] LED will be on.
2.
Enter the current Master Password. Control panel will emit 3 beeps if the valid password
is entered, otherwise a single long beep will be emitted and [PROG] LED will be off.
is entered, otherwise a single long beep will be emitted and [PROG] LED will be off.
3.
Enter [0], which represents “Erase Keychain / Receiver”. Notice all 5 zone LEDs, some of
them may be off, some of them may flash once, some of the may flash twice. The LED
flashing represents the occupied sensors.
them may be off, some of them may flash once, some of the may flash twice. The LED
flashing represents the occupied sensors.
•
If the zone LED remains off, that indicates that zone is not occupied by any keychain /
receiver.
receiver.
•
If the zone LED flashes once, that indicates a receiver has occupied that device. Zone 1
LED flashes once means Device 1 is occupied.
LED flashes once means Device 1 is occupied.
•
If the zone LED flashes twice, that indicates a keychain / keypad remote has occupied that
zone. Zone 1 LED flashes twice means Device 6 is occupied.
zone. Zone 1 LED flashes twice means Device 6 is occupied.
4.
To erase a receiver, enter a device number from Device 1 to Device 5. To select device 1,
press button 1. Once a device is selected, you will hear 3 beeps and “Device_ Empty
Memory”.
press button 1. Once a device is selected, you will hear 3 beeps and “Device_ Empty
Memory”.
5.
To erase a keychain, enter a device number from Device 6 to Device 0. To select device 6,
press button 6. Once a device is selected, you will hear 3 beeps and “Device_ Empty
Memory”.
press button 6. Once a device is selected, you will hear 3 beeps and “Device_ Empty
Memory”.
6.
To erase another remote / receiver, repeat the above steps.