Attenti TRXS-840-2 Manual De Usuario
E3 Receiver Unit and Transmitter Installation Guide
E3 Receiver Unit and Transmitter Installation Guide
E3 Receiver Unit and Transmitter Installation Guide
E3 Receiver Unit and Transmitter Installation Guide
12
To replace the Transmitter straps:
1. Using the screwdriver, open the screw(s) that holds the
strap clasp to the Transmitter and remove the strap clasp.
2. Gently shake the strap loose from the Transmitter body,
being extra careful not to damage the metal pins on the
Transmitter body.
Transmitter body.
3. Position the new strap over the Transmitter body. Notice
that the two small holes on the strap have to lie exactly over
the two metal pins.
the two metal pins.
4. Gently place the strap down over the metal pins and press
down along the seam of the strap, snugly fitting the entire
strap to the Transmitter body.
strap to the Transmitter body.
5. Put the strap clasp back in place with the wider side pointing
in-wards.
6. Close the screw (s) with the screwdriver. It has to be closed
firmly, but not too tight since this can damage the strap.
7. Test the new strap by performing a calibration. Refer to the
chapter about Installing the Transmitter.
Note: If, after the calibration, the Transmitter does not
reset, repeat steps 1-6 making sure that the strap is
positioned correctly over the pins. Then perform another
calibration test. If changing only one side of the strap does
not work, you should try and change the other strap side.
reset, repeat steps 1-6 making sure that the strap is
positioned correctly over the pins. Then perform another
calibration test. If changing only one side of the strap does
not work, you should try and change the other strap side.