Gorman Redlich Manufacturing Co CRW-S Manual De Usuario

 
 
 
 

The front panel of the CRW-S weather receiver features, from the left: 
 
 

1. Red alert LED labeled “ALERT” 

      2. To the right of the alert LED, a pushbutton switch labeled “MUTE-DEMUTE” 
 

3. Yellow “RELAY CLOSED” LED  

 

4. To the right of the relay LED, a pushbutton switch labeled “RELAY RESET” 
5. Orange “REPLAY ALERT” LED 
6. To the right of the replay LED, a pushbutton switch labeled “REPLAY ALERT” 
7. Green Power-on LED 
8. Volume control knob labeled “VOLUME 

                        9. Speaker 

 

      

 

 

   The rear panel of the CRW-S weather receiver features: 
 
1.  A table with the DIP switch positions for tuning to each of the seven weather service 

frequencies 

2.  An external antenna connector.  A female  F connector 
3.  A plug to wire in a 12V external power supply 
4.  The receptacle for the 15V DC power supply 
5.  The 8 position DIP switch for selecting the receiver operating frequency and programming the 

radio for the location of installation. 

6.  A ten terminal removable plug 
7.  A eight terminal removable plug 
8.  A  P.C. port for down loading the programming to the CRW-S 
9.  An auxiliary port to connect external equipment to the CRW-S such as a sign board. 
 
The positions on the 10 terminal strip, starting from the left end are: 
 
1:2  

A balanced 600 ohm continuous AUDIO OUT 

 
3:4  

A balanced 600 ohm AUDIO OUT that is gated on when the CRW-S detects incoming   

                   1050 Hz tone or when the front panel MUTE/DEMUTE button is toggled on.  
 
5:6  

A momentary contact closure across these terminals will toggle the internal relay on and  

                   off.     
 
7:8             When the internal relay is energized, a dry contact closure is supplied to these two  
                    terminals      
 
9:10 

Spare terminals for future use.