Gemtek Technology Co. Ltd. M940830G Manual De Usuario

1) 

The antenna must be installed such that 20 cm is 

maintained between the antenna and users, and   

2) 

The transmitter module may not be co-located with 

any other transmitter or antenna. 

As long as 2 conditions above are met, further transmitter test 

will not be required. However, the OEM integrator is still 

responsible for testing their end-product for any additional 

compliance requirements required with this module installed (for 

example, digital device emissions, PC peripheral requirements, 

etc.). 

 

IMPORTANT NOTE: In the event that these conditions can not 

be met (for example certain laptop configurations or co-location 

with another transmitter), then the FCC authorization is no 

longer considered valid and the FCC ID can not be used on the 

final product. In these circumstances, the OEM integrator will be 

responsible for re-evaluating the end product (including the 

transmitter) and obtaining a separate FCC authorization. 

 

 

 

This transmitter module is authorized only for use in device 

where the antenna may be installed such that 20 cm may 

be maintained between the antenna and users (for 

example : Access Point, Router… etc.). The final end 

product must be labeled in a visible area with the following: 

“Contains TX FCC ID: MXF-M940830G”. 

 

The OEM integrator has to be aware not to provide 

information to the end user regarding how to install or 

remove this RF module in the user’s manual of the end 

product which integrate this module. 

 

The users manual for OEM integrators must include the 

following information in a prominent location “ IMPORTANT 

NOTE: To comply with FCC RF exposure compliance 

requirements, the antenna used for this transmitter must be