Base Aviation Ltd. 4401B Manual De Usuario

We all know how painful it is to read equipment manuals.  In the interest of satisfying the novelty of
“hooking it up and trying it out” without going through the entire manual first, we have provided a short
“minimal” connection system to try it out;

1)  Connect a 12 volt power supply to the receiver at the power supply pigtail-see picture for  what

connection is a +12V and what is Gnd.  Be sure it’s correct before you turn the power on!

2)  Hook nothing else up to the receiver.

3)  Turn the 12V power on – the led indicator beside the setup button should blink once then go out.

4)  Press the set-up button 5 times in a row – not too fast – about 2 times a second.  The led should blink

5 times and go out.

5)  Take the transmitter and press any button on it – the corresponding led beside the relay channel on

the circuit board should light up – the relays are the little white blocks on the circuit board – the red
indicator LED’s are close to each of them.

THAT’S IT! – You have just taught the receiver to work with the transmitter and can operate the
channels in momentary mode.  There’s a lot more you can do but … you guessed it … you will have to
read the manual.

Thanks very much for purchasing this BASE Engineering remote control system.