Base Aviation Ltd. 4401B Manual De Usuario

NOTE:
While each channel can be set for emergency latched operation, there is only one reset button
that is connected to the receiver.  If more than one channel is set for emergency latched
operation all will be de-activated when the reset button is pressed.

All programmed settings are not lost when the power is turned off to the unit and will be active
the next time the receiver is powered up again.

There are no switches in either the receiver or transmitter units that are set an “ID” code
between the pair.  All transmitters have a unique signature code of ID that is factory set and
cannot be changed.  In order for a transmitter to operate a receiver, the receiver has to “learn”
the proper code of the transmitter.  It is also possible to clear the ID code in the receiver so that
any transmitter will operate the receiver.

Each transmitter unit contains a unique serial number or “ID Code” that is set at the factory and
cannot be altered in the field.  In order that a transmitter can operate a particular receiver unit,
the receiver unit must first “learn” the transmitter’s ID Code so that it will respond to commands
from that transmitter.

If a transmitter is used that has not been “learned” by the receiver, the receiver will not function
with that transmitter.  To teach a receiver the ID code of a transmitter, follow the steps below;

1)  Turn power off to the receiver.

2)  Remove the cover of the receiver unit and locate the set-up pushbutton on the internal

circuit board as well as the indicator led beside it.  This button is used to program all internal
settings in the receiver.

3)  Turn power on to the receiver – watch that the indicator led blinks once – this indicates that

the receiver is functioning properly.

4)  Press the set-up button 5 times in a row – not too slow – about 2 times a second.  Once the

button has been pressed 5 times in a row – watch the led indicator.  It should blink 5 times
to indicate it is now waiting for a transmitter to learn.

5)  Take the transmitter that is to be used with this receiver and press any button on it for 2

seconds or more.

6)  This completes the learning process.  The ID of this transmitter is stored in memory in the

receiver and will not be lost when the power is turned off.  The above process can be
repeated whenever a new or different transmitter is to be used with the receiver.  Only one
transmitter at a time can be used with the receiver.