Chamberlain Group Inc The 7471 Manual De Usuario

To prevent possible SERIOUS INJURY or 
DEATH from a moving gate or garage door:
•   ALWAYS keep remote controls out of 

reach of children. NEVER permit children 
to operate, or play with remote control 
transmitters.

•   Activate gate or door ONLY when it can be 

seen clearly, is properly adjusted, and 
there are no obstructions to door travel.

•   ALWAYS keep gate or garage door in sight 

until completely closed. NEVER permit 
anyone to cross path of moving gate or 
door.

This product is for use with model 850LM and 
860LM receiver. Depending on the receiver 
channel, you may program up to 20 or 50 
remote control dip switch configurations to your 
receiver. To exceed the 20/50 limit, match the 
dip switches in the new remote control to the 
dip switches in an existing remote control.

1   Slide the cover open to access the dip 

switches in the remote control.

2   Use a pen or screwdriver to slide the dip 

switches to any position you want (ON or 
OFF).

1   Press and release the Learn button for the 

selected channel on the receiver. The 
corresponding LED will glow steadily for 30 
seconds.

2   Within 30 seconds press and hold the button 

on the remote control that you wish to 
program to the receiver.

3   Release the remote control button when the 

LED on the receiver blinks, then turns off. 
Programming is complete.

Repeat the steps above for each remote control 
you would like to program.

Learn Buttons