Chamberlain Group Inc The 8439 Manual De Usuario
16
1
Connect Internet
The controller can connect to the Internet with LAN (wired) or with Wi-Fi
®
(wireless). Make sure you are in the Admin Mode
before you connect to the Internet. If you are not in Admin Mode, touch the upper left-hand corner of the display. Follow the
instructions according to your application.
instructions according to your application.
PRE-INSTALL
NETWORK
PROGRAMMING
INSTALL
ACCESS CONTROL
INTRODUCTION
On the display, select each tab in Admin Mode to validate setup
(network, inputs, outputs, etc.). Once you have validated the setup,
exit Admin Mode.
(network, inputs, outputs, etc.). Once you have validated the setup,
exit Admin Mode.
Validate Setup
2
OPTION 1
Connect with LAN (wired)
The Local Area Network (LAN) port is a 10/100 Ethernet
interface with an RJ45 jack for connecting the controller
to a LAN in order for it to gain connectivity to the Internet.
Use a straight, (i.e., non-crossover) cable to connect to
a local hub, switch or router. Connect the Power/Internet
Board to a LAN functionality is a supplementary feature.
interface with an RJ45 jack for connecting the controller
to a LAN in order for it to gain connectivity to the Internet.
Use a straight, (i.e., non-crossover) cable to connect to
a local hub, switch or router. Connect the Power/Internet
Board to a LAN functionality is a supplementary feature.
1. Connect an Ethernet cable from your LAN to the LAN
port on the Power/Internet Board. When connected
properly, the green and amber LED on the Ethernet
port will light/fl icker. If the green LED is not lit, check
the connections on the controller and the Ethernet
hub.
properly, the green and amber LED on the Ethernet
port will light/fl icker. If the green LED is not lit, check
the connections on the controller and the Ethernet
hub.
2. On the display, select Wired Network if dynamic
confi guration (DHCP) is desired or select Manual
Setup for a static IP address.
Setup for a static IP address.
OPTION 2
Connect through Wi-Fi
®
(Wireless)
1. On the display select Wi-Fi Network.
2. Select the network the controller will use.
3. Enter the password for the network.
4. Select
Login.
ON
LAN
on Internet/Power Board
Ferrite Core