Inovonics Wireless Corporation 3B6OTPMTX Manual De Usuario
Confidential
8
Chapter 2
EN1501-EXT Pulse Counting Transmitter for
Integration Installation Instructions
2.1 Connecting the EN1501-EXT Pulse Counting
Transmitter
Transmitter
The EN1501-EXT is designed to be easily interfaced with your meter or
product, however integration must conform to the following:
product, however integration must conform to the following:
A. The EN1501-EXT must only be connected at the four pin header.
B. All cables and wires must be routed away from the component side of the
EN1501-EXT.
C. The on-board antenna must not be tampered with; no connection to an
alternate antenna is provided.
D. The meter or product must not include an integrated secondary colocated
radio module.
E. The EN1501-EXT on-board antenna should be placed so that it is facing
away, or otherwise isolated from, your device’s ground plane.
F. Components that are sensitive to RF transmission, such as high gain
circuits, should be isolated from the on-board antenna to prevent
interference.
interference.
G. EN1501-EXTs should not be mounted on metal surfaces or inside metal
enclosures. They should also not be mounted where sheet metal ductwork,
wire mesh screens, etc. might block transmissions.
wire mesh screens, etc. might block transmissions.