Inovonics Wireless Corporation 3B6PORUNV Manual De Usuario

tab release window (see Diagram 2) and pressing it against the locking tab (see Diagram 1) while sliding the plate 
downward along the case back. 

 
3.  If a wired contact loop is to be used with concealed wiring, feed the wires through the concealed wiring entry hole at 

one corner of the mounting plate. 
For surface wiring entry, a thin “breakout” area is provided in the case wall. Wiring can be run through this “breakout” 
in the case when attaching the case step 5. 

4.  Install the mounting plate where the transmitter is to be mounted. Perform the WMG200 to ensure that the selected 

location is in range of wireless receiver. Use the flat head screws supplied. 

5.  Attach the case back to the mounting plate by sliding the keyhole slots in the case back down onto the mounting 

plate’s case holding posts. The locking tab will click as the case back locks in place. 

6.  If the unit’s reed switch is to be used, the Magnet (obtain separately) should be mounted adjacent to mounting plate’s 

alignment strip (see Diagram 2). 

 
Wiring Connections 
With the battery still not inserted, connect the contact loop (if used) to the unit’s loop terminals (see diagram). The contact 
loop must use closed circuit devices. The loop response time is about 400mSec. 
Note: If the contact loop is not to be used, no connection is needed across its terminals. 
 
BATTERY INSTALLATION/REPLACEMENT     
1.  Remove the transmitter’s cover (if is not already off) as described in Mounting step 1. 
2.  Observe correct polarity and insert the battery provided into the battery holder (see Diagram 2). Take care no to 

3.  To replace the cover, engage the hooks along one edge and snap shut. 
 
SPECIFICATIONS 
Dimensions  1-9/16″Wx3-1/16″Hx1-3/16″D(40mmx78mmx30mm) 

Battery  3V Lithium 
 
Battery CAUTION: Risk of fire, explosion and burns. Do not recharge, Short Circuit, Crush, 
Disassemble, Heat Above 212℉(100℃) or Incinerate. Dispose of used batteries promptly. 

Keep away from children.   
 
NOTE: 

S/N: (ZONE1 and ZONE2) 
         

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device 

may not cause harmful interference, and (2) this device must accept any interference received, including interference that 

may cause undesired operation. 

 

FCC Statement 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 

FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio communications