Honeywell International Inc. 7400-352 Manual De Usuario
70
•
•
•
•
•
•
To remove a battery pack, push the locking tab down and pull the battery out from
the charging pocket with a hinging motion.
the charging pocket with a hinging motion.
+
) ,-
To service battery packs, insert batteries into the charging pockets and press the
Condition button. The Condition LED will flash during the conditioning cycle. This
starts an automatic process where batteries are completely discharged and then
recharged to full capacity in eight hours. The Condition and Calibrate cycle resets
and calibrates battery data so that the user gets longer, more consistent
performance from the batteries. HHP recommends that battery packs should be
serviced, or calibrated once a month.
Condition button. The Condition LED will flash during the conditioning cycle. This
starts an automatic process where batteries are completely discharged and then
recharged to full capacity in eight hours. The Condition and Calibrate cycle resets
and calibrates battery data so that the user gets longer, more consistent
performance from the batteries. HHP recommends that battery packs should be
serviced, or calibrated once a month.
Because the Dolphin 7400 QuadCharger is accumulating battery pack information
during the entire Condition and Calibrate cycle, it is important not to remove the
battery until the cycle has been completed and the Condition LED is no longer
flashing. Batteries inserted after the “Condition and Calibrate” switch has been
depressed will receive a standard charge. The chart below describes the Status
LEDs during the Condition and Calibrate cycle:
during the entire Condition and Calibrate cycle, it is important not to remove the
battery until the cycle has been completed and the Condition LED is no longer
flashing. Batteries inserted after the “Condition and Calibrate” switch has been
depressed will receive a standard charge. The chart below describes the Status
LEDs during the Condition and Calibrate cycle:
Status LED
Description
Green
Charging is complete and
battery is ready for service.
battery is ready for service.
Orange
Battery is being charged at a
maximum charge rate
maximum charge rate
Red
Error was encountered during
charge cycle
charge cycle
Status of LEDs during Charging Cycle
Status LED
Description
Solid Green
Cycle is complete. Battery
remains in trickle charge until
removed from the charger.
remains in trickle charge until
removed from the charger.
Flashing Orange
Battery is being conditioned
Solid Red
Error was encountered during
charge cycle
charge cycle
Status of LEDs during Condition and Calibrate Cycle