Honeywell International Inc. 7400-476 Manual De Usuario
2 - 11
Putting the Dolphin Into Suspend Mode
To conserve power, press and hold the backlight key for approximately three seconds to put the Dolphin terminal into suspend
mode. The terminal may also go into “suspend mode” when it is inactive for a programmed period of time, as defined by your
application. Press the ON/SCAN key to wake the Dolphin terminal from suspend to start working where you left off.
mode. The terminal may also go into “suspend mode” when it is inactive for a programmed period of time, as defined by your
application. Press the ON/SCAN key to wake the Dolphin terminal from suspend to start working where you left off.
The Dolphin terminal also goes into sleep mode if you remove the main battery pack. To wake the Dolphin terminal from sleep
mode, install a charged battery and press the ON/SCAN key.
mode, install a charged battery and press the ON/SCAN key.
WARNING If the main battery and back-up battery are ever fully discharged of power, the terminal will cold boot. The
terminal will be restored to its original state. All data stored in RAM memory also will be lost.
terminal will be restored to its original state. All data stored in RAM memory also will be lost.
Resetting the Dolphin (Cold Boot)
Under some conditions, you may need to reset the Dolphin 7400/7450 terminal with a cold boot. These may include:
•
Resetting the operating system
•
Resetting the terminal back to factory defaults
•
Resetting the terminal after a bootloader, keyboard, and kernel upgrade
To perform a cold boot:
1. Press and hold the Control (CTRL) and the Escape (ESC) keys for about 10 seconds.
2. Release the keys and the terminal will reset. The red LED will come on and the green LED will blink for approximately 3
seconds.
3. The terminal will behave as described in the section about Starting the Dolphin for the First Time.
Resetting the Dolphin (Warm Boot)
There are times when you may need to warm boot the Dolphin 7400/7450 terminal, such as after loading a software application
that requires a warm boot after installing new software. To warm boot the Dolphin 7400 terminal:
that requires a warm boot after installing new software. To warm boot the Dolphin 7400 terminal:
1. Press and hold the Control (CTRL) and the SHIFT (SFT) keys for about 10 seconds, then release.
2. Release the keys and the terminal will reset. The red LED will come on and the green LED will blink for approximately 3
seconds.
3. The terminal will initialize and after a few seconds will display the main menu screen for the Dolphin 7400/7450 Demo
Program.