Honeywell International Inc. 9500LUPE Manual De Usuario
13 - 6
Dolphin® 9500 Series User’s Guide
Spring Arm Assembly
The spring arm assembly is the column that connects the latch to the back of the Mobile Base.
Ball Joints
There are two ball joints: one on the back of the Mobile Base and one on the mounting bracket. Both ball joints are
inserted into the bracket and secured to mount the Mobile Base.
inserted into the bracket and secured to mount the Mobile Base.
Connectors
The power and RS-232 connectors are located on the bottom panel. For more information, see
Brackets
Bracket
The bracket contains the turnscrew and two slots. Ball joints are inserted into each slot and secured with the
turnscrew.
turnscrew.
Turnscrew
The turnscrew is located on the top of the bracket. Rotate the turnscrew to secure or loosen the ball joint slots.
Mounting Bracket
The mounting bracket is what you attach to the mounting surface. It is comprised of a ball joint and flat disk. The
disk contains drill holes you use to secure the Mobile Base to the mounting surface.
disk contains drill holes you use to secure the Mobile Base to the mounting surface.
Powering the Dolphin Mobile Base
Note: Hand Held Products recommends that you leave the Mobile Base connected to its power source at all times.
The Mobile Base is powered via the power connector on the bottom panel; see
Both the power and
serial connectors are straight out, not at an angle. The Mobile Base must be powered by a 12 to 48 volt DC source.