Honeywell International Inc. MX2702 Manual De Usuario

If the scanner isn’t reading symbols well, check that the symbols:

•

Aren’t smeared, rough, scratched, or exhibiting voids.

•

Aren’t coated with frost or water droplets on the surface.

•

Are enabled in the base to which the scanner connects.

Is the bar code displayed but not entered into the application?

The bar code is displayed on the host device correctly, but you still have to press 
a key to enter it (the Enter/Return key or the Tab key, for example).

You need to program a suffix.  Programming a suffix enables the scanner to 
output the bar code data plus the key you need (such as “CR”) to enter the data 
into your application.  Refer to 

information.

Does the scanner read the bar code incorrectly?

If the scanner reads a bar code, but the data is not displayed correctly on the host 
screen:

•

The base may not be programmed for the appropriate terminal interface. 
For example, you scan “12345” and the host displays “@es%.”

Reprogram the base with the correct Plug and Play or Terminal selection bar 
code.  See 

.

•

The base may not be programmed to output your bar code data properly.
For example, you scan “12345” and the host displays “A12345B.”

Reprogram the base with the proper symbology selections.  See 

.

The scanner won’t read your bar code at all.

1. Scan the sample bar codes in the back of this manual.  If the scanner reads 

the sample bar codes, check that your bar code is readable.
Verify that your bar code symbology is enabled (see 

).  

2. If the scanner still can’t read the sample bar codes, scan 

If you aren’t sure what programming options have been set in the base, or if you 
want the factory default settings restored, scan 

•

Is the base powered?

•

Does the scanner illuminate?

•

Are the radios set up? within range?