Acer W100 Manual De Usuario
Striiv Touch Quick Start Guide
Includes:
Includes:
1. Striiv Touch device
2. USB Cable
3. Charging Cradle
4. Quick Start Guide
2. USB Cable
3. Charging Cradle
4. Quick Start Guide
Instructions:
1. Open Charging Cradle.
2. Line up charging pins of the Striiv Touch with pins of Charging Cradle.
3. Set Striiv Touch into Charging Cradle so that pins of the device and pins of
2. Line up charging pins of the Striiv Touch with pins of Charging Cradle.
3. Set Striiv Touch into Charging Cradle so that pins of the device and pins of
the cradle are in contact.
4. Close the Charging Cradle. You will hear a click.
5. Plug the small end of USB Cable into Charging Cradle.
6. Plug the large end of the USB Cable into a compatible USB socket.
7. Allow Striiv Touch device to charge for at least 90 minutes.
8. Visit
5. Plug the small end of USB Cable into Charging Cradle.
6. Plug the large end of the USB Cable into a compatible USB socket.
7. Allow Striiv Touch device to charge for at least 90 minutes.
8. Visit
www.striiv.com/setup
to complete the setup of your device.
FCC Statement
Model: W100
FCC ID: HLZW100
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment under FCC rules. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation of
the device. FCC RF Radiation Exposure Statement: This equipment complies with