Sysgration Ltd. AXM-607 Manual De Usuario

AXM-607 Wireless Optical Mouse User Manual

AXM-209C User Manual

1. Connecting with Computer:
    The first time you take out this mouse and
receiver from the packing, Factory Preset ID
enables Plug and Play function.

    Plug the Receiver into PC
USB Port . Under Win2000
or higher , wait for the OS to
detect the RF device.

Under Win98 or lower,

installation of driver for the
device is necessary.

    Insert the batteries into
the mouse and move it for a while , then it
starts working .

2. Inserting Batteries:

Push the battery

cover compartment
backward and open it .

Insert 2 AAA batteries

into the compartment with
correct orientation .

B. Slide the battery cover

into the compartment and
close the cover .

3. ID Link:

When Factory ID has been changed or

wish to be changed , link ID as below :

A. Press the ID button on

the bottom of the mouse .

B. Press the ID button on

the top of the receiver. If
the led on it starts blinking
rapidly , ID Link is OK .

! ID linking should be completed within

10 seconds or connection would be failed

4. Power Saving Mode:

A. Suspend Mode :
Keep mouse stationary for 10 minutes,

mouse will be automatically
set to Suspend Mode. Press
left button to wake up the

mouse again.

B. Power Off Mode :

When you wish to set the mouse to

power off mode, press mouse ID for 3
seconds . The Optical Led will flash once
and then fade out, showing mouse power
is already off. Press ID switch for waking
up again .

5. Trouble Shooting:

A. When mouse doesn’t respond, check

the battery power status, and link ID again.

B. Be sure the Receiver is connected

properly to the USB port of the PC.

C. Ask for maintenance solution from

your retailer and engineer . Personally
taking apart is prohibited after trouble
happened.

FCC Note :

This equipment has been tested and comply with the limits for a

class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection. This equipment
generates, uses and can radiated radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation if
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for

help.

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate
the equipment.

The antenna(s) used for this transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter