Sysgration Ltd. AXM-913P Manual De Usuario

2.4G Wireless Mouse and Receiver Users’ Guide 

Installation 
1.    Plug the receiver into a USB port on your computer. 
2.    Insert battery into the mouse.   
3.    This mouse provides factory default ID and so the link will be set up after a while. 
4.    Click the mouse key and her response will be read on the monitor.   

 

1.  No connection between the mouse and the receiver.   

Re-insert the receiver. Try to insert receiver to another USB port on your computer. 

2.    No any response on the mouse. 

Take out the battery from the mouse and reinstall it with correct orientation. Try a 

new battery if necessary.   

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference  

to radio or television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures: 

-Reorient or relocate the receiving antenna. 

-Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

To assure continued compliance, any changes or modifications not expressly approved by the party 

responsible for compliance could void the user’s authority to operate this equipment. (Example- use only 

shielded interface cables when connecting to computer or peripheral devices). 

 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and it 

also complies with Part 15 of FCC RF Rules. Operation is subject to the following two conditions: 

1) This device may not cause interference and 

2) This device must accept any interference, including interference that may cause undesired operation of the 

device. 

 

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to 

this equipment. Such modifications could void the user authority to operate the equipment.