Honeywell International Inc. RTU-B07 Manual De Usuario

A combined wall assembly of single and triple modules allows you to

create units consisting of 2, 4 and 5 units. This procedure consists

of the following steps:

1. Drill the necessary holes in the wall (2 plastic dowels for each

module), so that the lower plate will cover the hole through which
the cables pass.

2. Insert the cables in the cable clamp without pulling out the screws.
3. Link the frames together by inserting the two enclosed attachment

clips at the rear of the frames (see Figure 6 and Figure 7).

4. Use the dowels to fasten the frame to the wall. Make sure that

the lamellar connector is in the UP position.

5. Adjust the length of the cables so that they protrude by ~10cm

from the wall, and fasten them to the cable crimp.

6. Intertwine the terminators of the cables from the wall and the

extension cable terminators, and fasten them to the cable crimps.

7. Fasten the cable crimp to the contacts in the direction shown in

Figure 6 and Figure 7.

8. Place the remainder of the cable inside the frame and lock the cable

clamp.

NET1

NET2

GND

+12V

NET1

NET2

GND

+12V