Honeywell International Inc. RTU-K03 Manual De Usuario

To identify the node, you can call the service pin by means of a relay-

reed located inside the unit (see Figure 13). This procedure consists

of the following steps:

1. Position a small magnet as illustrated in Figure 13 to call the

service pin. This signal is linked to the yellow central service LED,

which flashes throughout the node configuration procedure.

2. The TemaServer, in response to the service pin, sends a wink

command that makes yellow LED flash three times. This allows you

to verify that the communication to and from the TemaServer is

working.

3. Check that the service LED remains off after you have completed

this operation.

SERVICE

LED

service pin

(reed)