Zero One Technology Co. Ltd. WP03002 Manual De Usuario
67
are damaged. In addition, check the cable connection. If the pins are damaged, contact your
dealer for a replacement connector.
dealer for a replacement connector.
Windows 95/98/Me/NT/2000/XP Troubleshooting
Multi-Segment LAN Environment Installation (through the Network Print Port)
If your print server and Windows 95/98/Me/NT/2000/XP are located on two different
segments, and your Windows NT server is used as the router/gateway you will need to
implement the following procedures in order for your print server to function properly:
If your print server and Windows 95/98/Me/NT/2000/XP are located on two different
segments, and your Windows NT server is used as the router/gateway you will need to
implement the following procedures in order for your print server to function properly:
Add the RIP for NWLink IPX/SPX compatible transport. See RIP for NWLink IPX/SPX
compatible transport Installation Procedure later in this section.
compatible transport Installation Procedure later in this section.
Add the frame type 802.2 for both Ethernet adapters. See Multi-Segment Frame Type
802.2 Installation later in this section.
802.2 Installation later in this section.
RIP for NWLink IPX/SPX compatible transport Installation Procedure
1. From your Windows NT server that is used as a router, select Start from the bottom left
hand corner of the screen.
2. Select
Settings.
3. Select
Control Panel.
4. Double-click
the
Network icon.
5. Select
Services.
6. Select
Add.
7. In the Select Network Service box, select the RIP for NWLink IPX/SPX compatible
transport. Click OK.
8. Follows the directions on the screen.
9. Done!
9. Done!
Multi-Segment Frame Type 802.2 Installation
1. From your Windows NT server that is used as a router, select Start from the bottom left
hand corner of the screen.
2. Point
to
Settings, and select Control Panel.
3. Double-click
the
Network icon.
4. Select
Protocols.Select the NWLink IPX/SPX Compatible Transport.
5. Select
Properties.
6. Select your (first) network interface card and select Manual Frame Type Detection.
7. Click
7. Click
Add.
8. In
the
Frame Type field, select Ethernet 802.2.
9. In
the
Network Number field, type in an unique 8-digit hexadecimal network number.
For example: 12345ABC.
10. Select Add.