Binsfeld Engineering Inc TX10K-LP Manual De Usuario
- 15 -
GAIN
▲
Increases the gain setting of the TX10K. If the Transmitter Gain is
already at the maximum value, the Status Indicator on the TX10K
will flash only once, indicating the command was received but not
carried out.
GAIN
already at the maximum value, the Status Indicator on the TX10K
will flash only once, indicating the command was received but not
carried out.
GAIN
▼
Decreases the gain setting of the TX10K. If the gain is already at
the minimum value, the Status Indicator on the TX10K will flash
only once, indicating the command was received but not carried
out.
CHANNEL
the minimum value, the Status Indicator on the TX10K will flash
only once, indicating the command was received but not carried
out.
CHANNEL
▲
Increases the RF channel of the TX10K. If the channel is already
at the maximum value, the Status Indicator on the TX10K will flash
only once, indicating the command was received but not carried
out.
CHANNEL
at the maximum value, the Status Indicator on the TX10K will flash
only once, indicating the command was received but not carried
out.
CHANNEL
▼
Decreases the RF channel of the TX10K. If the channel is already
at the minimum value, the Status Indicator on the TX10K will flash
only once, indicating the command was received but not carried
out.
SENDING Light
The SENDING light will come on for about 1 second when a key is
pressed. This indicates the RM10K is sending a signal. It is not
an indication that the TX10K has received the signal. The Status
Indicator on the TX10K or the display on the RX10K can be
monitored to confirm successful command transmission.
If the SENDING light flashes after a key is pressed, the battery in
the RM10K is low and should be replaced. If the SENDING light
does not come on at all after a key is pressed, the battery is dead
and needs to be replaced.
As mentioned in the previous section, the SENDING light will stay
on for about 3 seconds after the TRANSMITTER ON key has
been pressed. This indicates the RM10K is in high power mode,
and any command sent during the next 3 seconds will be at the
high infrared power level.
at the minimum value, the Status Indicator on the TX10K will flash
only once, indicating the command was received but not carried
out.
SENDING Light
The SENDING light will come on for about 1 second when a key is
pressed. This indicates the RM10K is sending a signal. It is not
an indication that the TX10K has received the signal. The Status
Indicator on the TX10K or the display on the RX10K can be
monitored to confirm successful command transmission.
If the SENDING light flashes after a key is pressed, the battery in
the RM10K is low and should be replaced. If the SENDING light
does not come on at all after a key is pressed, the battery is dead
and needs to be replaced.
As mentioned in the previous section, the SENDING light will stay
on for about 3 seconds after the TRANSMITTER ON key has
been pressed. This indicates the RM10K is in high power mode,
and any command sent during the next 3 seconds will be at the
high infrared power level.