Senstar Corporation LM100 Manual De Usuario

Segment Settings and Zone assignments

Segment

The Segment field identifies the currently selected Segment; 
The selected Segment is divided into 2 equal Segment and the 
Segment

 number increments when you select the Split button;

The currently selected Segment merges with the previous Segment 
and the Segment number decrements when you select the Delete 
button; The LM100 system supports up to 50 segments

Zone

Specify the Zone to which the selected Segment is assigned; The 
LM100 system supports up to 50 zones 

Relay 
(Local Control mode)

Specify the Relay which will activate in response to an alarm 
condition in the selected Segment

Sequence button

The Sequence button is used to setup and define the physical 
locations of the installed luminaires

Profile button

The Sensitivity Profile records the detection signal response 
magnitude for each luminaire based on a similar disturbance along 
the full length of the protected fence

Split button

Select the Split button to divide the currently selected Segment into 
two equal segments

Delete button

Select the Delete button to merge the currently selected Segment 
with the preceding segment

Schedule tab

Setup automatic lighting controls for the defined luminaire zones

SD Card tab

Select the type of data that will be saved to an SD card on the 
LM100 gateway (troubleshooting feature)

Aux Cfig tab (setup the method of control and the I/O response)

Aux Control

Select Local to have the I/O controlled by the gateway; 
Select Remote to have the I/O controlled by the host security 
management system

Aux Option Card

Select Input if the processor includes an optional input card; 
Select Output if the processor includes an optional output card

Aux type

Specify each of the ten I/O ports as either an Input or Output

Input Configuration

Setup the gateway’s inputs and the optional input card’s 4 inputs

Output Configuration

Setup the gateway’s relay outputs and the optional output card’s 4 
outputs

Network Cfig tab

Setup the Silver Network communication parameters

GSM Cfig tab

Setup the parameters for the Senstar Wireless Gate Sensor

Remote Cfig tab

Specify outputs that will activate in response to alarm and 
supervision conditions for Senstar LM100s that are reporting alarms 
and supervision conditions through an UltraLink I/O system 
operating in Network Manager mode