ZyXEL Communications Corporation 5VZ-A2011 Manual De Usuario
Chapter 2 Tutorials
CellPipe 7130 RG User’s Guide
33
2.2.3.1 Connecting to a Wireless LAN
The following sections show you how to join a wireless network using a wireless
utility, as in the following diagram. The wireless client is labeled C and the access
point is labeled AP.
utility, as in the following diagram. The wireless client is labeled C and the access
point is labeled AP.
There are three ways to connect the client to an access point.
• Configure nothing and leave the wireless client to automatically scan for and
connect to any available network that has no wireless security configured.
• Manually connect to a network.
• Configure a profile to have the wireless client automatically connect to a specific
• Configure a profile to have the wireless client automatically connect to a specific
network or peer computer.
This example illustrates how to manually connect your wireless client to an access
point (AP) which is configured for WPA-PSK security and connected to the
Internet. Before you connect to the access point, you must know its Service Set
IDentity (SSID) and WPA-PSK pre-shared key. In this example, the SSID is
“SSID_Example3” and the pre-shared key is “ThisismyWPA-PSKpre-sharedkey”.
point (AP) which is configured for WPA-PSK security and connected to the
Internet. Before you connect to the access point, you must know its Service Set
IDentity (SSID) and WPA-PSK pre-shared key. In this example, the SSID is
“SSID_Example3” and the pre-shared key is “ThisismyWPA-PSKpre-sharedkey”.
After you install the wireless utility and then insert the wireless client, follow the
steps below to connect to a network using the Site Survey screen.
steps below to connect to a network using the Site Survey screen.
1
Open the wireless utility and click the Site Survey tab to open the screen shown
next.
next.
Utility: Site Survey
C
AP