ZyXEL Communications Corporation EMG1302R10A Manual De Usuario
Chapter 19 Remote Management
EMG1302-R10A User’s Guide
139
19.5 The Telnet Screen
You can use Telnet to access the EMG1302-R10A’s command line interface. Specify which interfaces
allow Telnet access and from which IP address the access can come.
allow Telnet access and from which IP address the access can come.
Click Configuration > Management > Remote MGMT > Telnet to display the screen as shown.
Figure 77
Configuration > Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
Access Status
Select the interface(s) through which a computer may access the EMG1302-R10A using
this HTTP service.
this HTTP service.
Secured Client IP
Address
Address
Select All to allow all computers to access the EMG1302-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG1302-R10A.
the EMG1302-R10A.
Apply
Click Apply to save your changes back to the EMG1302-R10A.
Cancel
Click Cancel to exit this screen without saving.
Table 56
Configuration > Management > Remote MGMT > WWW (continued)
LABEL
DESCRIPTION
Table 57
Configuration > Management > Remote MGMT > Telnet
LABEL
DESCRIPTION
Port
You may change the server port number for a service if needed. However you must use
the same port number in order to use that service for remote management.
the same port number in order to use that service for remote management.
Access Status
Select the interface(s) through which a computer may access the EMG1302-R10A using
this service.
this service.
Secured Client IP
Address
Address
Select All to allow all computers to access the EMG1302-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG1302-R10A.
the EMG1302-R10A.
Apply
Click Apply to save your changes back to the EMG1302-R10A.
Cancel
Click Cancel to exit this screen without saving.