ZyXEL Communications Corporation EMG1302R10A Manual De Usuario

 Chapter 8 Wireless LAN

EMG1302-R10A User’s Guide

Use this screen when you want to add a wireless station using WPS. To open this screen, click 
Configuration > Network > Wireless LAN > WPS Station.

Note: After you click Push Button on this screen, you have to press a similar button in 

the wireless station utility within 2 minutes. To add the second wireless station, you 

have to press these buttons on both device and the wireless station again after the 

first 2 minutes.

Configuration > Network > Wireless LAN > WPS Station

The following table describes the labels in this screen.

Apply

Click Apply to save your changes back to the EMG1302-R10A.

Cancel

Click Cancel to exit this screen without saving.

Configuration > Network > Wireless LAN > WPS (continued)

Configuration > Network > Wireless LAN > WPS Station

Push Button

Use this button when you use the PBC (Push Button Configuration) method to configure 
wireless stations’s wireless settings.

Click this to start WPS-aware wireless station scanning and the wireless security 
information synchronization.

Or input station’s 
PIN number

Use this button when you use the PIN Configuration method to configure wireless 
station’s wireless settings.

Type the same PIN number generated in the wireless station’s utility. Then click Start 
to associate to each other and perform the wireless security information 
synchronization.