ZyXEL Communications Corporation EMG6765-Q10A Manual De Usuario

 Chapter 1 Introduction

EMG6765-Q10A User’s Guide

Press the WPS button for more than one second and release it. Press the WPS button on another WPS-
enabled device within range of the EMG6765-Q10A. 

Note: You must activate WPS on the EMG6765-Q10A and on another wireless device within 

two minutes of each other. 

For more information on using WPS, see 

.

The LED indicators are located on the front panel. Look at the LED lights on the front panel to determine 
the status of the EMG6765-Q10A. Front Panel

The following table describes the LEDs.

Table 1   Front Panel and Rear panel LEDs 

Power

On

The EMG6765-Q10A is receiving power and functioning properly. 

Off

The EMG6765-Q10A is not receiving power.

Internet

On

The EMG6765-Q10A has an IP connection but no traffic.

Your device has a WAN IP address (either static or assigned by a DHCP server), 
PPP negotiation was successfully completed (if used) and the connection is up.

Blinking 

The EMG6765-Q10A is sending or receiving IP traffic.

Off

The EMG6765-Q10A does not have an IP connection.

WLAN 2.4/5G

(White)

On

The EMG6765-Q10A is ready, but is not sending/receiving data through the 5G 
wireless LAN. 

Blinking

The EMG6765-Q10A is sending/receiving data through the 5G wireless LAN.

The EMG6765-Q10A is negotiating a WPS connection with a wireless client.

Off

The wireless LAN is not ready or has failed.

WLAN 2.4/5G

(Amber)

On

The EMG6765-Q10A is setting up a WPS connection with a 2.4GHz or 5GHz 
wireless client.

Off

The 2.4 GHz or 5GHz WPS process is completed or failed.