ZyXEL Communications Corporation NBG4104 Manual De Usuario

 Chapter 21 Bandwidth Management

NBG4104 User’s Guide

You can limit an application’s uplink bandwidth. This limit keeps the traffic from using up too much 
of the out-going interface’s bandwidth. This way you can make sure there is bandwidth for other 
applications. Use the following guidelines:

• The sum of the bandwidth allotments that apply to the WAN interface (LAN to WAN, WLAN to 

WAN) must be less than or equal to the Uplink value that you configure in the Bandwidth 
Management General screen. 

Use this screen to enable bandwidth management and assign uplink limits. You can use either one 
of the following types:

• Priority Queue. Enable bandwidth management to give uplink traffic that matches a bandwidth 

rule priority over traffic that does not match a bandwidth rule. (This type does not apply to 
downlink traffic.) 

• Bandwidth Allocation. Enabling bandwidth management also allows you to control the 

maximum or minimum amounts of bandwidth that can be used by traffic that matches a 
bandwidth rule.

Note: You cannot apply both bandwidth management types at the same time.

Click Configuration > Management > Bandwidth MGMT to open the bandwidth management 
General screen.

Configuration > Management > Bandwidth MGMT > General