ZyXEL Communications Corporation NBG418NV2 Manual De Usuario

Chapter 9 DHCP Server

Network > DHCP Server > General   

The following table describes the labels in this screen.

This screen allows you to assign IP addresses on the LAN to specific individual computers based on 
their MAC addresses. You can also use this screen to configure the DNS server information that the 
NBG-418N sends to the DHCP clients.

To change your NBG-418N’s static DHCP settings, click Network > DHCP Server > Advanced. 
The following screen displays.

Network > DHCP Server > General

Enable DHCP Server

Enable or Disable DHCP for LAN.

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows 
individual clients (computers) to obtain TCP/IP configuration at startup from a server. 
Leave the Enable DHCP Server check box selected unless your ISP instructs you to 
do otherwise. Clear it to disable the NBG-418N acting as a DHCP server. When 
configured as a server, the NBG-418N provides TCP/IP configuration for the clients. If 
not, DHCP service is disabled and you must have another DHCP server on your LAN, 
or else the computers must be manually configured. When set as a server, fill in the 
following four fields.

IP Pool Starting 
Address

This field specifies the first of the contiguous addresses in the IP address pool for LAN.

Pool Size

This field specifies the size, or count of the IP address pool for LAN.

Apply

Click Apply to save your changes back to the NBG-418N.

Reset

Click Reset to begin configuring this screen afresh.