ZyXEL Communications Corporation NWA5301NJ Manual De Usuario
Chapter 1 Introduction
NWA5301-NJ User’s Guide
21
1.6 Starting and Stopping the NWA
Here are some of the ways to start and stop the NWA.
Always use Maintenance > Shutdown or the shutdown command before
you turn off the NWA or remove the power. Not doing so can cause the
firmware to become corrupt.
you turn off the NWA or remove the power. Not doing so can cause the
firmware to become corrupt.
The NWA does not stop or start the system processes when you apply configuration files or run
shell scripts although you may temporarily lose access to network resources.
shell scripts although you may temporarily lose access to network resources.
PoE
Green
On
Power is supplied to the yellow PoE Ethernet port (LAN1).
Off
There is no power supply.
WLAN
Green
On
The WLAN is active.
Blinking
The WLAN is transmitting or receiving data.
Off
The WLAN is not active.
UPLINK
Green
On
The port is connected.
Blinking
The NWA is sending/receiving data through the port.
Off
The port is not connected.
LAN1-3
Green
On
The port is connected.
Blinking
The NWA is sending/receiving data through the port.
Off
The port is not connected.
Table 4
NWA LEDs (continued)
LABEL
COLOR
STATUS
DESCRIPTION
Table 5
Starting and Stopping the NWA
METHOD
DESCRIPTION
Turning on the power
A cold start occurs when you turn on the power to the NWA. The NWA powers up,
checks the hardware, and starts the system processes.
checks the hardware, and starts the system processes.
Rebooting the NWA
A warm start (without powering down and powering up again) occurs when you use
the Reboot button in the Reboot screen or when you use the reboot command. The
NWA writes all cached data to the local storage, stops the system processes, and then
does a warm start.
the Reboot button in the Reboot screen or when you use the reboot command. The
NWA writes all cached data to the local storage, stops the system processes, and then
does a warm start.
Using the RESET
button
button
If you press the RESET button on the back of the NWA, the NWA sets the
configuration to its default values and then reboots. See
configuration to its default values and then reboots. See
more information.
Clicking
Maintenance >
Shutdown >
Shutdown or using
the shutdown
command
Maintenance >
Shutdown >
Shutdown or using
the shutdown
command
Clicking Maintenance > Shutdown > Shutdown or using the shutdown command
writes all cached data to the local storage and stops the system processes. Wait for
the device to shut down and then manually turn off or remove the power. It does not
turn off the power.
writes all cached data to the local storage and stops the system processes. Wait for
the device to shut down and then manually turn off or remove the power. It does not
turn off the power.
Disconnecting the
power
power
Power off occurs when you turn off the power to the NWA. The NWA simply turns off.
It does not stop the system processes or write cached data to local storage.
It does not stop the system processes or write cached data to local storage.