ZyXEL Communications Corporation PRESTIGE310S Manual De Usuario

Remote Node Setup

Make sure that Encapsulation is set to PPPoE in Menu 11.1. Then move the cursor to the Edit IP field in
Menu 11.1, press the [SPACE BAR] to toggle No to Yes.  Press [Enter]

 

to open Menu 11.3 - Network

Layer Options.

The next table gives you instructions about configuring remote node network layer options.

IP Address
Assignment

If your ISP did not assign you an explicit IP address, select Dynamic;
otherwise select Static and enter the IP address & subnet mask in the
following fields.

Dynamic

Rem IP Address

If you have a Static IP Assignment, enter the IP address assigned to
the remote node.

Rem IP Subnet
Mask

If you have a Static IP Assignment, enter the subnet mask assigned to
the remote node.

My WAN Addr

Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network number.
If this is the case, enter the IP address assigned to the WAN port of
your Prestige.

Note that this is the address assigned to your local Prestige, not the
remote router.

Single User
Account

Use the [SPACE BAR] to choose Yes or No.

Yes

Menu 11.3 - Remote Node Network Layer Options

                    IP Address Assignment= Dynamic
                    Rem IP Address= N/A
                    Rem Subnet Mask= N/A
                    My WAN Addr= 0.0.0.0

                    Single User Account= Yes
                    Metric= 1
                    Private= No
                    RIP Direction= None
                      Version= N/A
                    Multicast= None

                     Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.