ZyXEL Communications Corporation VMG1312T10C Manual De Usuario
Chapter 25 Remote Management
VMG1312-T10C User’s Guide
208
25.3 Telnet Screen
You can use Telnet to access the Device’s command line interface. Specify which interfaces allow
Telnet access and from which IP address the access can come.
Telnet access and from which IP address the access can come.
Click Maintenance > Remote MGMT > Telnet tab to display the screen as shown.
Figure 143
Maintenance > Remote MGMT > Telnet
The following table describes the labels in this screen.
Apply
Click this to save your changes.
Cancel
Click this to restore your previously saved settings.
Table 86
Maintenance > Remote MGMT > WWW (continued)
LABEL
DESCRIPTION
Table 87
Maintenance > Remote MGMT > Telnet
LABEL
DESCRIPTION
Server Port
This displays the service port number for accessing the Device. If the number is grayed
out, it is not editable.
out, it is not editable.
Server Access
Select the interfaces through which a computer may access the Device using this service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule.
WAN, you will need to configure a WAN to Router firewall rule.
Secured Client IP
Address
Address
A secured client is a “trusted” computer that is allowed to communicate with the Device
using this service.
using this service.
Select All to allow any computer to access the Device using this service.
Choose Range to just allow the computers with an IP address in the range that you
specify to access the Device using this service.
specify to access the Device using this service.
Apply
Click this to save your changes.
Cancel
Click this to restore your previously saved settings.