ZyXEL Communications Corporation WAC6503D-S Manual De Usuario

Chapter 12 System

NWA5000 / WAC6500 Series User’s Guide

You must install an SSH client program on a client computer (Windows or Linux operating system) 
that is used to connect to the NWA/WAC over SSH.

Click Configuration > System > SSH to open the following screen. Use this screen to configure 
your NWA/WAC’s Secure Shell settings.

Note: It is recommended that you disable Telnet and FTP when you configure SSH for 

secure connections.

Configuration > System > SSH

The following table describes the labels in this screen.  

This section shows two examples using a command interface and a graphical interface SSH client 
program to remotely access the NWA/WAC. The configuration and connection steps are similar for 
most SSH client programs. Refer to your SSH client program user’s guide.

Configuration > System > SSH

Enable

Select the check box to allow or disallow the computer with the IP address that matches 
the IP address(es) in the Service Control table to access the NWA/WAC CLI using this 
service.

Version 1

Select the check box to have the NWA/WAC use both SSH version 1 and version 2 
protocols. If you clear the check box, the NWA/WAC uses only SSH version 2 protocol.

Server Port

You may change the server port number for a service if needed, however you must use the 
same port number in order to use that service for remote management.

Server 
Certificate

Select the certificate whose corresponding private key is to be used to identify the NWA/
WAC for SSH connections. You must have certificates already configured in the My 
Certificates screen.

Apply

Click Apply to save your changes back to the NWA/WAC. 

Reset

Click Reset to return the screen to its last-saved settings.