ZyXEL Communications Corporation WAP5805 Manual De Usuario
Chapter 4 Tutorials
WAP5805 User’s Guide
24
4.2.1 Connecting to the Internet from an Access Point
This section gives you an example of how to set up an access point (A) and wireless client (B in this
example) for wireless communication. Computers that connect to B can access the Internet
through the access point wirelessly.
example) for wireless communication. Computers that connect to B can access the Internet
through the access point wirelessly.
Figure 10
Wireless Access Point Connection to the Internet
4.2.2 Push Button Configuration (PBC)
1
Make sure that your WAP5805s are turned on and that they are within range of each other.
2
Make sure the WPS (
) buttons of both WAP5805s are on.
3
Press the WPS buttons for more than three seconds. The WPS LEDs blink.
Note: It doesn’t matter which button is pressed first. You must press the second button
within two minutes of pressing the first one.
Note: Your WAP5805 has a WPS button located on its panel, as well as a WPS button in
its Web Configurator. Both buttons have exactly the same function; you can also
log into the Web Configurator and press the Push Button in the AP’s
Configuration > Network > Wireless LAN > WPS Station screen and the PBC
Start button in the client’s Configuration > Network > Wireless LAN > WPS
screen.
The AP sends the proper configuration settings to the wireless client. This may take up to two
minutes. Then the wireless client is able to communicate with the AP securely.
minutes. Then the wireless client is able to communicate with the AP securely.
A
B