Garmin International Inc 0037600 Manual De Usuario
Preliminary
GTX 327 Installation Manual
Page 7
190-00187-02
Rev 1
A.
Trim coax outer insulation back 0.50”.
B.
Trim braid (not center conductor or insulation) back 0.25”.
C.
Strip Insulation back 0.120”.
NOTE
Place the ferrule over the coax braid, flush against the coax outer insulation before performing
the next step if the outside diameter of the coax braid is smaller than the inside diameter of the
center connector sidewall opening.
the next step if the outside diameter of the coax braid is smaller than the inside diameter of the
center connector sidewall opening.
D.
Insert cable (center conductor, dielectric and shield braid) through the sidewall of the connector
and solder the center conductor to the center pin of the connector.
and solder the center conductor to the center pin of the connector.
NOTE
When using low loss cable it may be necessary to flatten the solid wire center conductor slightly
so it can fit the slot on the RF connector center pin. When soldering, avoid applying excess heat
to the connector body, and center conductor insulator.
so it can fit the slot on the RF connector center pin. When soldering, avoid applying excess heat
to the connector body, and center conductor insulator.
E.
Heat the outside of the connector sleeve and at the same time apply solder between the braid
and the sleeve. Continue to apply heat until the solder flows evenly.
and the sleeve. Continue to apply heat until the solder flows evenly.
F.
Install 50
V Matching Bushing.
G.
Insert connector cap and tack solder in two places.