Garmin International Inc 0037600 Manual De Usuario
Preliminary
GTX 327 Installation Manual
Page 3
190-00187-02
Rev 1
1.6
INSTALLATION ACCESSORIES
The following installation accessories are available:
•
GARMIN GTX 327 Installation Kit, P/N 010-10216-00 containing Connector/Rack Kit,
P/N 011-00338-00 (see figure B-2 for connector/rack kit assembly drawing).
P/N 011-00338-00 (see figure B-2 for connector/rack kit assembly drawing).
•
GARMIN GTX 327 Antenna Kit, P/N 010-10160-00. Note: A transponder antenna approved to TSO
C66( ) or C74( ) that has been installed to meet the requirements of this manual may be approved for
use with the GTX 327.
C66( ) or C74( ) that has been installed to meet the requirements of this manual may be approved for
use with the GTX 327.
1.7
ADDITIONAL EQUIPMENT REQUIRED
•
Antenna Sealant - Use antenna manufacturer’s instructions, install according to FAA AC 43.13-2A.
•
Cables - The installer will supply all system cables. Cable requirements and fabrication is detailed in
Section 2 of this manual.
Section 2 of this manual.
•
Hardware - #6 Flat Head Screw (6 ea.) and #6-32 Self-Locking Nut (6 ea.). Hardware required to
mount installation rack is not provided.
mount installation rack is not provided.
•
Encoding Altitude Digitizer - Use encoding altimeter manufacturer’s instructions, install according to
FAA AC 43.13-2A.
FAA AC 43.13-2A.
1.8
INSTALLATION APPROVAL
The conditions and tests required for TSO approval of the GTX 327 Transponder and antenna are minimum
performance standards. It is the responsibility of those desiring to install this transponder and antenna either
on or within a specific type or class of aircraft to determine that the aircraft installation standards are within
the TSO standards. The GTX 327 and antenna may be installed only if further evaluation by the applicant
documents an acceptable installation and is approved by the administrator. For GTX 327 TSO compliance,
see Appendix A. For antenna TSO compliance, refer to antenna manufacturer’s literature.
performance standards. It is the responsibility of those desiring to install this transponder and antenna either
on or within a specific type or class of aircraft to determine that the aircraft installation standards are within
the TSO standards. The GTX 327 and antenna may be installed only if further evaluation by the applicant
documents an acceptable installation and is approved by the administrator. For GTX 327 TSO compliance,
see Appendix A. For antenna TSO compliance, refer to antenna manufacturer’s literature.