Garmin International Inc 0058501 Manual De Usuario

3

190-00302-01  Page Rev. 1   

Garmin G1000  VHF NAV/COM Pilot’s Guide

Frequencies located in the  active fi eld are displayed 

in either   green or   white.

•   An  active frequency that is displayed in   green 

indicates that the corresponding radio is selected 
(i.e., in use).

•   An  active frequency that is displayed in   white 

indicates that the corresponding radio is not 
selected.

Frequencies located in the  standby fi eld are displayed 

in either   white or  gray.

•   The  standby frequency that appears in the tuning 

box is displayed in   white.

•   The  standby frequency that is not in the tuning 

box is displayed in  gray.

NOTE: In GPS mode, both active NAV frequencies 
are displayed in   white.

NOTE: In split COM mode, both active COM 
frequencies are displayed in   green.

On both the  PFD and the  MFD, a  cyan tuning box ap-

pears over the  standby frequency fi eld and can be moved 
from one  standby frequency fi eld to another for the pur-
pose of tuning or radio selection.

In both the COM and NAV windows, the frequency 

toggle arrow appears next to the tuning box, between the 
active and standby frequencies.

A  Frequency Toggle Arrow appears between the two 

frequencies of the radio sub-window on which the fre-
quency tuning box is located.  Pressing the dual COM or 
 NAV knob toggles both the frequency tuning box and the 
 Frequency Toggle Arrow between the radios.

NOTE: If the frequency tuning box is on a 
selected COM sub-window when a signal 
is received or transmitted for this radio, the 
 Frequency Toggle Arrow is replaced by an 
 RX or a  TX

indication, respectively.

NOTE: When the desired frequency is entered in 
the tuning box, it becomes a  standby frequency.  
Pressing the  Frequency Toggle key places this 
 standby frequency into the  active fi eld, and vice 
versa.

•    RX – When a signal is received on a COM radio, 

a   white  RX indication appears to the right of the 
corresponding COM frequency for the duration of 
the signal reception.

•    TX – When a microphone is keyed, a   white  TX 

indication appears to the right of the correspond-
ing COM frequency for the duration of the signal 
transmission.

•    ID – When the  VOL/PUSH  ID knob is pressed, a 

  white  ID indication appears to the left of the NAV 
frequency on the selected NAV sub-window and 
the  Morse code identifi er audio for the selected 
 VOR frequency can be heard if the corresponding 
NAV radio is selected on the  audio panel.

!

!

!

!

G1000_COM-NAV_PG.indd   3

2/10/2004, 8:47:24 AM