Garmin International Inc 00855 Manual De Usuario
GPS 10 Technical Specifications (P/N 190-00516-00)
Rev. A
Page 26
Comm Menu
The Comm (Communication) Menu allows you to set the port number, baud rate, and then connect and
disconnect from the sensor.
disconnect from the sensor.
Setup: Opens the Comm Setup Window, shown to the left. Select
the Serial Port to which the sensor is connected from the drop-
down list. Then select Auto (the program determines the baud rate
on its own) or Manual (you then enter the baud rate) for the Baud
Rate entry.
the Serial Port to which the sensor is connected from the drop-
down list. Then select Auto (the program determines the baud rate
on its own) or Manual (you then enter the baud rate) for the Baud
Rate entry.
Connect: Select Connect to connect to the sensor to change or
view the configuration.
view the configuration.
Disconnect: Select Disconnect to disconnect from the sensor.
Config Menu
The Config (Configuration) Menu allows you
configure the sensor as it is connected.
configure the sensor as it is connected.
Sensor Configuration (F6): Opens the Sensor
Configuration Window, shown to the right. Many of
the fields in this window should be left alone. Please
refer to the beginning of this manual for clarification
about some of these fields. For the most part, this
window is used to enter a new Latitude, Longitude,
and Altitude for the sensor. This is especially helpful
when you are programming the sensor for use in a
particular geographic location.
Configuration Window, shown to the right. Many of
the fields in this window should be left alone. Please
refer to the beginning of this manual for clarification
about some of these fields. For the most part, this
window is used to enter a new Latitude, Longitude,
and Altitude for the sensor. This is especially helpful
when you are programming the sensor for use in a
particular geographic location.
Resetting the Unit (Reset Unit) performs a reset on the
unit, much like cycling the power.
unit, much like cycling the power.
Resetting the non-volatile memory (Reset NonVol)
will clear all of the data from the non-volatile memory.
will clear all of the data from the non-volatile memory.
NMEA Sentence Selections (F7): Displays the
NMEA Sentence Selections Window. If the sentence is
enabled, a check mark appears in the box to the left of
the sentence name. Click the box to enable or disable
to the sentence.
NMEA Sentence Selections Window. If the sentence is
enabled, a check mark appears in the box to the left of
the sentence name. Click the box to enable or disable
to the sentence.