Garmin International Inc 02723 Manual De Usuario

Adjust the angle of the camera and tighten the hex bolts using the included

hex key.

Apply RV sealant around the cable where it enters the vehicle (optional).

Before you permanently install the transmitter, you must test the installation

location for correct operation (page 2).

Secure the transmitter to the installation location using hardware appropriate

for the location, such as screws, bolts, or cable ties.
The fuse holder located near the transmitter is not waterproof. Installing the

fuse holder in a location that is exposed to the elements is not recommended.

Connect the camera and transmitter cables.
The connector between the camera and the transmitter is not waterproof. If

you make this connection in a location exposed to the elements, you must

make sure that the connection is waterproof.

Connect the power cable 

À

 from the transmitter to a 12–24 VDC power

source, preferably a reverse lamp 

Á

, using a solderless wire-splice

connector (not included).

NOTE: Connecting the transmitter to an always-on 12-24 VDC source (such

as a running lamp) instead of a reverse lamp requires you to manually switch

power to the transmitter. The transmitter may drain your vehicle battery if it is

left on.

If you did not use a solderless wire-splice connector, solder and heat-shrink

the electrical connections to protect them from the elements.

You must install AA batteries in the camera before you can pair it to a compatible

Garmin navigation device.

Turn on the compatible Garmin navigation device, and bring it within 3 m

(10 ft.) of the camera.

Select Apps > Backup Camera, and follow the on-screen instructions.

You can pair up to four wireless cameras with a compatible Garmin device. For

example, you can pair one backup camera installed on the cab and a second

backup camera installed on a trailer. See the BC 35 Owner's Manual for

information about pairing multiple cameras.

You can get the most recent owner's manual from the web.

Go to garmin.com/manuals/BC35.

View or download the full owner's manual in your preferred format.

Camera and transmitter input voltage

From 9 to 28 Vdc

Transmitter fuse

500 mA, fast-blow

Camera and transmitter current usage

150 mA at 12 Vdc

4