Garmin International Inc 03336 Manual De Usuario

Failure to heed the following notice could result in personal or property damage,

or negatively impact the device functionality.
GPS Notice

The navigation device may experience degraded performance if you use it in

proximity to any device that uses a terrestrial broadband network operating close

to the frequencies used by any Global Navigation Satellite System (GNSS), such

as the Global Positioning Service (GPS). Use of such devices may impair

reception of GNSS signals.
Product Environmental Programs

Information about the Garmin

®

 product recycling program and WEEE, RoHS,

REACH, and other compliance programs can be found at www.garmin.com

/aboutGarmin/environment.
Declaration of Conformity

Hereby, Garmin declares that this product is in compliance with the Directive

2014/53/EU. The full text of the EU declaration of conformity is available at the

following internet address: www.garmin.com/compliance.
Innovation, Science and Economic Development Canada Compliance

This device complies with Innovation, Science and Economic Development

Canada license-exempt RSS standard(s). Operation is subject to the following

two conditions: (1) this device may not cause interference, and (2) this device

must accept any interference, including interference that may cause undesired

operation of the device.
Radio Frequency Radiation Exposure

This device is a mobile transmitter and receiver that uses an internal antenna to

send and receive low levels of radio frequency (RF) energy for data

communications. The device emits RF energy below the published limits when

operating in its maximum output power mode and when used with Garmin

authorized accessories. To comply with RF exposure compliance requirements,

the device should be installed and operated with a minimum of 20 cm (7.87 in.)

between the device and your body. The device should not be used in other

configurations. This device must not be co-located or operated in conjunction

with any other transmitter or antenna.
FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and may cause harmful interference to radio communications if not

installed and used in accordance with the instructions. However, there is no

guarantee that interference will not occur in a particular installation. If this

2