Lexmark International Inc 0528RFU Manual De Usuario

1. Load about 20 pages of RFID media into the Standard Option.

2. While pressing the “3” and “6”, perform a “Soft Power On” to the CS725 Test Printer.
    The printer will power on in the “Diagnostic Mode”.   Scroll down and select “RFID Test”.

3. Select “Test Page 1”.  Test page one will print out.  Following the instructions on this
sheet, place this ”Test Page 1” back into the Standard Option printed side up with the
arrow pointing toward the front of the printer.  If this test page prints out, then this part of
the Function Test is successful.

4. Select “Test Page 2”.  Test page two will print out (this sheet is the same actual sheet as
Test page one.  Follow the instructions on this sheet, load one page of normal, non-RFID
media into the Standard Option. If this test page prints out, then this part of the Function
Test is successful.

5. Select “Test page 3”. Test page three will print out.  This page should duplex and print a
“Invalid Tag” on the back side.  Note the Instructions on the front side of the Test page
three.  If “Invalid Tag” is on the back side, then the full Function Test is successful.

6. Perform a “Soft Power off” to the printer.  Remove the RFID Option from the test set-up.

PN &

Description

Qty

ASSEMBLY INSTRUCTIONS

Rev. Date: 15 Sept 2016

Pg 13

PN: 40C0745 or

40C0747

Name: 550 Tray ASM RFID (NA or EU)

Lxk contact: Ward Inabinet (859-227-
4670)

Tool /

Fixture ID

Description