CalAmp 500004 Manual De Usuario
2.
EXTERNAL INTERFACES
2.1.
Power Connection
The connector on the core module is the Molex 43045-0401:
The mating connector (required for the power cable) is the Molex 43025-0400.
The contact required on the mating cable is the Molex 43030-0002
The core module is powered either from the J18 power connector or from the Meter Interface
Connector. The pinout of the J18 power connector is below. The pinout of the Meter Interface
Connector is in its own section. For specifications on the digital input, see the External I/O section.
The mating connector (required for the power cable) is the Molex 43025-0400.
The contact required on the mating cable is the Molex 43030-0002
The core module is powered either from the J18 power connector or from the Meter Interface
Connector. The pinout of the J18 power connector is below. The pinout of the Meter Interface
Connector is in its own section. For specifications on the digital input, see the External I/O section.
Table 1: DC Power Connector (J18)
Pin
Signal
1
V_IN (9-28VDC)
2
GND
3
DIGITAL_IN4
4
NO CONNECT
Note: Do not connect independent power supplies to the power connector and the power
inputs on the Interface Board Connector (P6). The power inputs are shorted on the core
module and connecting both could cause a high current condition.
inputs on the Interface Board Connector (P6). The power inputs are shorted on the core
module and connecting both could cause a high current condition.
Pinout