CalAmp 520006 Manual De Usuario
P/N: 131908/A
Revised: 9/1/00
Revised: 9/1/00
C+A
2
GENERAL INSTALLATION
INSTRUCTIONS FOR TRANSCEIVER
NOTE to System Operator:
California Amplifier family of Transceiver products has been designed for
installation by a licensed or qualified installer with experience in installing
wireless antennas.
installation by a licensed or qualified installer with experience in installing
wireless antennas.
NOTE to INSTALLER:
1. Installation and operation of this family of Transceiver products require full
compliance with FCC-adopted radio frequency exposure limits. It is in the
responsibility of the installer to install these devices and their associated
antennas so that RF exposure does not exceed 1.0mW/cm
responsibility of the installer to install these devices and their associated
antennas so that RF exposure does not exceed 1.0mW/cm
2
. The following
table summarizes the minimum distance required to satisfy these
requirements.
requirements.
Limits, Minimum
P/N
Integrated Planar (17 dBi)
Standalone (when used with 24 dBi)
520005-1
N/A
26 in. (66 cm)
520004-1
N/A
48 in. (122 cm)
520006-1
N/A
26 in. (66 cm)
520007-2
22 in. (55 cm)
N/A
520024-2
22 in. (55 cm)
N/A
520004-2
22 in. (55 cm)
N/A
520006-2
22 in. (55 cm)
N/A
2. When installing a standalone Transceiver, orient the FCC RF exposure label
is facing the front of the Antenna This is a mandatory requirement by the
FCC to comply with RF exposure compliance requirements. The label
should not be obstructed when installation is complete. This will allow the
warning label to be visible and readable. This is a mandatory requirement
by the FCC to comply with RF exposure compliance requirements
FCC to comply with RF exposure compliance requirements. The label
should not be obstructed when installation is complete. This will allow the
warning label to be visible and readable. This is a mandatory requirement
by the FCC to comply with RF exposure compliance requirements