Kingston Technology 4GB DDR3 1333MHz Kit KVR1333D3LD8R9S/4GEC Hoja De Datos
Los códigos de productos
KVR1333D3LD8R9S/4GEC
KVR1333D3LD8R9S/4GEC
4GB 2Rx8 512M x 72-Bit PC3-10600
CL9 Registered w/Parity 240-Pin DIMM
CL9 Registered w/Parity 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 512M x 72-bit (4GB)
DDR3L-1333 CL9 SDRAM (Synchronous DRAM), low voltage,
registered w/parity, 2Rx8 ECC memory module, based on
eighteen 256M x 8-bit DDR3L-1333 FBGA components. The
SPD is programmed to JEDEC standard latency DDR3-1333
timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact
fingers. The electrical and mechanical specifications are as
follows:
FEATURES
•
JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
•
VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
•
667MHz fCK for 1333Mb/sec/pin
•
8 independent internal bank
•
Programmable CAS Latency: 9, 8, 7, 6
•
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
•
8-bit pre-fetch
•
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•
Bi-directional Differential Data Strobe
•
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•
On Die Termination using ODT pin
•
On-DIMM thermal sensor (Grade B)
•
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•
Asynchronous Reset
•
PCB : Height 1.180” (30.00mm), double sided component
Document No. VALUERAM0958-001.B00 07/11/11 Page 1
SDRAM SUPPORTED
Elpida (C-Die)
Memory Module Specifi cations
SPECIFICATIONS
CL(IDD)
9 cycles
Row Cycle Time (tRCmin)
49.5ns (min.)
Refresh to Active/Refresh
160ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin)
36ns (min.)
Power (Operating)
(1.35V) = TBD*
(1.50V) = TBD*
UL Rating
94 V - 0
Operating Temperature
0
o
C to 85
o
C
Storage Temperature
-55
o
C to +100
o
C
*Power will vary depending on the SDRAM and
Register/PLL used.
Register/PLL used.
Continued >>