SMC Networks SMCSR01Z Manual De Usuario

 

If the TouchScreen reports a Tamper trouble 
or A/C power trouble for the device, be sure 
it is pushed all the way into the outlet, so 
the tamper switch is pressed against the 
wall. Add rubber pads to the tamper button 
if necessary to ensure the tamper button is 
pressed firmly when secured to a wall outlet. 

After you complete the installation, perform the 
following test procedure: 
Note: Additionally, test the Range Extender at 
least once a year to verify correct operation. 

On the TouchScreen tap the Settings app and 
enter you key pad code. 

At the Settings menu, tap Security > Alarm 
Test. The Alarm Test Options screen 
appears. 

Toggle the Disabled/Enabled button to 
Disabled by tapping it. This prevents your 
test alarm from being sent to the central 
monitoring station. 

 

IMPORTANT:  If you enable Send Test Alarm 
Messages, contact your central monitoring 

station and tell them you are testing your 

system. 

Tap Next. The Alarm Test Checklist appears. 

Ensure all the security zones are unfaulted 
(that is, doors and windows closed, motion 
detectors not showing motion, etc.). 

When the security zones are ready for 
testing, Ready to Arm appears below the 
Arm button.  

Tap Arm. Your security system is armed in 
the special Test mode. The Exit Delay is only 
10 seconds long. Motion sensors are turned 
off (not tripping alarms, but recording 
events) until an Entry/Exit security zone is 
faulted. The Arm button changes to a System 
Armed notice. 

Confirm that the Siren Repeater LED is red. 

Tap Next. The Alarm Test screen appears. 

Open and close an Entry/Exit door. The Entry 
Delay period starts (default 30 seconds). The 
TouchScreen beeps once per second and 
speeds up to twice per second in the last 10 

seconds of the Entry Delay period. Motion 
detectors are turned on. 
When the alarm sounds

, confirm that the 

SMC Siren Repeater is sounding and the 
White LED is flashing. 

Deleting a siren from the premises removes it

from the customer’s system. Only delete a si
to de-install the siren from the premises. To 

 

r n 

battery in the compar
battery cover. 

e

reset the sensor to factory default settings, 
delete the sensor and re-add it immediately. 

At the TouchScreen Home screen, tap the 
Settings app. 

On the Settings screen, use the keypad to 

enter the Installer Code.  

On the Technician Code/Id screen, enter 
your Technician ID and tap Done. 
At the Technician Setting

s menu, select 

Home Devices > Sirens > Delete Siren. The 
Remove Siren screen appears. 
Tap the icon of the siren you want to delete.  
When a confirmation dialog asks you t

o verify 

you want to delete the siren, tap Yes. The 
siren is deleted from the system.  
Open the battery cover with a PH1 screw 
driver and disconnect the battery. Leave the 

tment and reseal the