SMC Networks SMCWK01Z Manual De Usuario

With a Phillips screwdriver, remove 
the screw from the battery cover in 

the back of the key pad and 
remove the cover. 

Find the two supplied CR2 3-volt 
lithium batteries. 

On the front of the key pad, hold 
down the 2 and 8 buttons while 

inserting one of the batteries in th
back of the key pad (positive end 

up). 

e 

Continue to hold down the 2 and 

8 buttons until the 

 button 

lights green, then release 
immediately.  

The 

 button flashes green 3 

times every 5 seconds. This means 
the device is in Search mode and 

can be added to the TouchScreen. 

If the 

 button stops blinking, touch the STAR

to restart Search mode. 

 butto

Insert the other battery and replace the key pad back 
cover.

 

 

n 

From the Home screen, touch the Settings widget. 

When the TouchScreen Keypad screen appears, touch 
the numbers to enter the Installer keypad code (this 

code is the same for all TouchScreens installed by your 
company). 

When the Technician keyboard pad appears, enter your 

Technician ID and touch Done. 

When the Technician Settings menu appears, select Key 
Fobs & Pads > Add a Key Pad. The Locating Key Pads 
screen appears. 

Touch Next, and the system scans the premises for key 
pads that can be added, which must meet the following 
requirements: 

Defaulted 

Not currently paired with another TouchScreen. 

In Search Mode (blinking 3 times every 5 seconds) 

Follow the system prompts to complete the add process 
and pair the key pad with the TouchScreen. 

If no available key pads are found, touch Cancel Key 

Pad Add to return to the Technician Settings menu.  

Arm the system from the key pad to test that the key 
pa  h

d

 

as been added successfully.

Deleting a key pad from the premises removes it from being 

used to perform actions in your security system. You should 
delete a key pad: 

 

If the key pad is being relinquished by the customer. 

¾

¾

 

To reset the key pad to factory default settings by 
deleting the key pad and re-adding it to the TouchScreen 

immediately. 

Congratulations on purchasing your SMCWK01-Z Key Pad. 

The SMCMT02-Z Key Pad is a professional state-of-the-art device that lets you arm and disarm your system from additional locations in your home. It also provides an emergency alarm 
function.  

To delete a key pad from the TouchScreen:  

Perform steps A through D in step 2, “Adding a Key Pad 
to the TouchScreen”. 

When the Technician Settings menu appears, select Key 

Fobs & Pads > Delete a Key Pad. The Remove Key Pad 
screen appears. 

Touch the key pad icon that you want to delete. A 
confirmation dialog appears. 

Touch Yes. The key pad is deleted from the 
TouchScreen. 

After deleting the key pad from the TouchScreen, press 

the 

 button to reset the device to default and place 

it in Search mode so it can be added to a TouchScreen 

again.  

If a key pad does not appear to be working properly or is not 

being located by the TouchScreen during the Add process: 

¾

 

Verify that two good batteries have been properly 
installed (see step 1, “

.” 

 Pre-Installation Guidelines

¾

 

Confirm that the key pad has been defaulted.