HID Global Corporation 4045 Manual De Usuario
HID
CORPORATION
13
SELECTING A FILLER OR REQUEST TO EXIT LABEL
The filler piece replaces the antenna housing on the controller
keypad when you use the high security installation. If you do
not plan to use the filler piece as a Request to Exit switch:
keypad when you use the high security installation. If you do
not plan to use the filler piece as a Request to Exit switch:
1. Insert the filler piece into the opening on the
controller keypad.
2. Apply the blank label.
controller keypad.
2. Apply the blank label.
FIGURE
8:
ATTACHING THE ANTENNA HOUSING
If you plan to use the filler piece as a Request to Exit switch:
1. Remove the two plastic side tabs on the filler piece.
2. Insert the silicone rubber cushion over the two
alignment pins on the switch activator.
3. Apply the “Press to Exit” label to the filler piece.
4. Insert the filler piece into the opening on the
controller keypad.
5. Refer to Figure 15 to make the wiring connections
to the cable assembly if you are using a door contact.
6. Set the internal Request to Exit button ON, using
programming Command 30, option 7 (see Table 2).
2. Insert the silicone rubber cushion over the two
alignment pins on the switch activator.
3. Apply the “Press to Exit” label to the filler piece.
4. Insert the filler piece into the opening on the
controller keypad.
5. Refer to Figure 15 to make the wiring connections
to the cable assembly if you are using a door contact.
6. Set the internal Request to Exit button ON, using
programming Command 30, option 7 (see Table 2).