HID Global Corporation 4045 Manual De Usuario
HID
CORPORATION
1
INTRODUCTION
This EntryProx User’s Guide provides basic information and
instructions for installing, wiring, and programming the
EntryProx unit.
instructions for installing, wiring, and programming the
EntryProx unit.
IMPORTANT
•
YOU MUST KEEP A USER LIST
when
programming cards and PIN codes into your EntryProx.
Write down the User Location, Card Number, PIN Code
and the Name of the User. Use the blank form in
Appendix A as a photocopy master.
Write down the User Location, Card Number, PIN Code
and the Name of the User. Use the blank form in
Appendix A as a photocopy master.
•
DO NOT PROGRAM A CARD OR PIN IN USER
LOCATION 1
LOCATION 1
for normal access control use. User
Location 1 is reserved for the MASTER CODE,
which places the unit into programming mode.
which places the unit into programming mode.
•
CHANGE THE MASTER CODE
from the factory
default, after initial programming, and write this code
down and keep it in a safe place.
down and keep it in a safe place.
•
IF YOU LOSE OR FORGET THE MASTER
CODE
CODE
:
End Users: contact your dealer –a service call is
required. Dealers: call HID Technical Support.
•
CONSIDER A SECURE INSTALLATION
if
installing on an exterior door or high-risk location.
FCC WARNING
Changes or modifications not expressly approved by the party
responsible for compliance could void the users’ authority to
operate this equipment. The reader is intended to be
powered from a limited power source output of a previously
certified power supply.
responsible for compliance could void the users’ authority to
operate this equipment. The reader is intended to be
powered from a limited power source output of a previously
certified power supply.
UL 294 COMPLIANCE
The EntryProx Unit complies with UL 294 Standard for
Access Control Units in a standard wall-mount installation,
only when installed in strict accordance with UL
requirements. Please refer to page 14 for details
Access Control Units in a standard wall-mount installation,
only when installed in strict accordance with UL
requirements. Please refer to page 14 for details
.